Eltako 61100903 EUD61M-8 .. 230VUC dimmer switch,

Universal dimmer switch. Power MOSFET up to 400W. Automatic lamp detection. Standby loss only 0.1 watt. Minimum brightness adjustable. With children's room and snooze function. For recessed mounting. 45mm long, 45mm wide, 18mm deep. Universal dimmer switch for lamps up to 400W, depending on the ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps also dependent on the lamp electronics. Zero-crossing switching with soft on and soft off to protect the lamp. Universal control voltage 8..230V UC, galvanically isolated from the supply and switching voltage 230V. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. An interruption in the control changes the dimming direction. The set brightness level remains stored in the memory functions when switched off. In the on-max functions, the device is always switched on at the maximum brightness level. In the event of a power failure, the switch position and brightness level are saved and switched on when the supply voltage is restored, if necessary. Automatic electronic overload protection and overtemperature shutdown. The upper %lamp rotary switch can be used to set the minimum brightness (fully dimmed), e.g. for dimmable energy-saving lamps. Automatic operation allows all types of lamp to be dimmed. The lower function rotary switch can be used to select between five automatic operation functions: memory, memory+soft on, on max, on max+soft on and ESV+soft on. +ESL is a comfort position for energy-saving lamps which, due to their design, have to be switched on with a higher voltage so that they can switch on again when cold when dimmed. -ESL is a comfort position for energy-saving lamps which, due to their design, cannot be switched on again when dimmed. Memory is therefore switched off in this position. Inductive (wound) transformers must not be used in the +ESL and -ESL positions. In addition, the maximum number of dimmable energy-saving lamps can be lower than in automatic mode due to the design. ESV function setting as memory+soft on with setting of a release delay on the %lamp rotary switch of up to 90 minutes if the lamp has not been switched off manually. At the end, switch-off advance warning by dimming within 1 minute. With children's room switch: When switching on by pressing the button for a longer period, the lamp switches on at the lowest brightness after approx. 1 second and, as long as the button is continued, slowly dims up without changing the last saved brightness level. With snooze function: A double pulse dims the lighting from the current dimming position to the minimum brightness and then switches it off. The max. dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly.You can turn the light off at any time by pressing the button briefly during the dimming process. A long press during the dimming process dims the light up and ends the snooze function. L loads (inductive loads, e.g. wound transformers) and C loads (capacitive loads, e.g. electronic transformers) must not be mixed. R loads (ohmic loads, e.g. 230V incandescent and halogen lamps) can be mixed in as desired.
Type: EUD61M-8..230VUC