Eltako 61100830 EUD61NP-230V wall box dimmers,

Without N connection, power MOSFET up to 400W. Standby loss only 0.5 watts. With control inputs for light buttons and light switches. Minimum brightness and dimming speed adjustable. For flush mounting. 45mm long, 45mm wide, 18mm deep. Universal dimmer switch for R, L and C loads up to 400W depending on the ventilation conditions. Automatic detection of load type R+L or R+C. Not suitable for 230V LED lamps and energy-saving lamps ESL, please use EUD61NPL or the dimmer EUD61NPN with N connection. Zero-crossing switching with soft on and soft off to protect the lamp. Control voltage 230V. Minimum load 20W. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. Interrupting the control changes the dimming direction. The set brightness level is saved when switched off. In the event of a power failure, the switch position and brightness level are saved and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and overtemperature shutdown. The minimum brightness (fully dimmed) can be set using the upper % lamp rotary switch. The dimming speed can be set using the lower dim speed rotary switch. The duration of soft on and soft off can be changed at the same time. In the event that light switches cannot be replaced by light buttons, there is a separate control input for light switches: If the closed switch is briefly opened again, it dims until it is briefly opened again. The dimming direction changes automatically at the two vertices. The direction can also be changed by briefly opening the switch twice. With children's room circuit (only when controlled with a button): When switched on by pressing the button for a longer period, the light is switched on at the lowest brightness after approx. 1 second and, as long as the button is continued, it slowly dims up without changing the last saved brightness level. With snooze function (only when controlled with a button): A double pulse dims the lighting from the current dimming position to the minimum brightness and then switches it off. The maximum dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can be shortened accordingly. The lighting can be switched off at any time by pressing the button briefly during the dimming process. A long press during the dimming process dims the light up and ends the snooze function. No N connection, so suitable for installation directly behind the light button or light switch, even if there is no N cable. L loads (inductive loads, e.g. wound transformers) and C loads (capacitive loads, e.g. electronic transformers) must not be mixed. R loads (ohmic loads, e.g. 230V incandescent and halogen lamps) can be mixed in as required.
Type: EUD61NP-230V