EasyRaid Q16 +, RAID 0/1/3/5/6/TP, 48,3 cm ( 19 inch )rack 3U, demo content_copy

The easyRAID ® disk arrays are an inexpensive entry into the RAID technology. Despite the comparatively low price of the RAID systems offer uncompromised features for security and performance.

High data security:

With RAID 6 can vary up to 3 hard disks without data loss up to 2 in RAID TP (triple parity). Thus, the data security over RAID 5 increases significantly as during a rebuild persists redundancy. If in a RAID level 1 -, 3 -, 5 -, 6 - a drive fails or TP configuration, the missing data is reconstructed through the array controller without interruption in service. In an existing hot spare drive automatically starts a reconstruction process on the new hard drive. This also starts at a drive replacement. After the initial failure of security is restored.

High Performance:

The easyRAID ® Q16 + combines 16 SATA-II hard drives in an enclosure, so tremendously large storage capacities possible. The easyRAID ® Q16 + disk array is equipped with two Ultra320 SCSI host interfaces. This enables data transfer up to 320 MB / sec per port and makes the device capable of dual host. Alternatively, the system with 2Gbit/sec or 4Gb / s Fibre Channel Dual Loop sec is available with 200 or 400 MB / per host. The parallel operation of internal disk transfer rates can be achieved that are higher than those of the individual drives - with very high security.

SMART Correction Technology:

Disk Self Test: HDD Self self-test can directly easyRAID ® Q16 + be performed.
Disk Scrubbing: The easyRAID ® Q16 + checks the integrity of the data in the background. Bad sectors are detected and corrected at the same parity error.
Disk Cloning: The easyRAID ® Q16 + periodically checks the health of hard drives and automatically or manually duplicated in error data to a hot spare disk, long before the failed disk fails.

Ease of Installation:

The easyRAID ® Q16 + is independent of the operating system and is like a big SCSI hard drive installed. A user-friendly, browser-based RAID management GUI software simplifies administration and monitoring. These controls automatic Drive-fail detection, hot swapping, online expansion, reconstruction and background-bad-sector reassignment.

Specifications:

2x Ultra320 SCSI
16x 3 ½ "SATA hot swappable
512MB cache (up to 1024MB possible)
2x460W Redundant hot-swappable power supplies
RAID levels 0, 1, 0 +1, 3, 5, 6, Triple Parity (6 +), 30 or 50, JBOD
Support of standby disk
Battery backup unit available as an option
LAN port to manage the RAID over Ethernet.
occupies only 3U of rack 48,3 cm ( 19 inch )

Accessories:

including ext. SCSI cable and terminator
including rackmount rails


This is a low-use demo.