Eltako 30100862 FSR70S-230V-rw wireless actuator power impulse relay pure white content_copy

1 normally open contact not potential-free 10A/250V AC, 230V LED lamps up to 400W, incandescent lamps 2000W, ESL up to 200W. Standby loss only 0.8 watts. Installation in the 230V mains connection cable of floor and bedside lamps. 100mm long, 50mm wide and 31mm high. This radio actuator as a current impulse switching relay has the most modern hybrid technology developed by us: We have combined the wear-free reception and evaluation electronics with a bistable relay that switches at zero crossing. This means that there is no coil power loss and no heating as a result, even when switched on. With the rotary switch on the side, up to 35 radio buttons can be assigned in the LRN positions, including one or more central control buttons. In addition, a radio motion brightness sensor FBH and/or a radio outdoor brightness sensor FAH for a presence simulation. The desired function of this impulse switching relay is then selected: ES = impulse switch. With the FBH taught-in, the light is switched on when there is movement, and with the FAH additionally taught-in, it is switched on at dusk. When no more movement is detected, the contact opens with a 4-minute delay. A radio button can also be taught in to activate or deactivate a presence simulation. ER = switching relay. With the FAH taught-in, the light is switched on at dusk, and when it is bright, the contact opens with a 4-minute delay. AS = presence simulation. The AS begins with a random pause time of between 20 and 40 minutes, followed by a random switch-on time of between 30 and 120 minutes. If the rotary switch is turned to AS or the mains voltage is switched on in the AS position, the light switches on for 5 seconds after 1 second. With the FAH taught-in, the AS only begins when dusk sets in. After the FAH has detected brightness, the AS ends after 4 minutes. The LED on the side accompanies the learning process according to the operating instructions and indicates radio control commands during operation by flashing briefly.