RUNPOTEC 10203 RP5 including digital meter counter 30m cable pull-in tape for pipe Ø16-40mm

The RP5 - RUNPOTEC Polyester Ø 5.5 mm is a cable pulling tool including a digital meter counter (for determining the length of pipes/cables or for creating cable lists). The triple-twisted special plastic tape Ø 5.5 mm has an even better thrust effect than the fiberglass rod Ø 3 mm and the frictional resistance is only half as great due to its point-based support. The patented RG7 guide tip with twist compensation Ø 5.5 mm (pressed at the beginning and end of the tape) enables the tightest radii to be overcome (bending radius 15 mm). The RP5 - RUNPOTEC Polyester Ø 5.5 mm is stored in a robust storage box with an ergonomic handle that is suitable for construction sites. This is equipped with the new push-back safety device that prevents the cable pulling tape from accidentally slipping back. The unit of measurement of the meter counter can be changed from metric (m) to imperial (ft). The total breaking load of an incredible 270 kg refers to the entire pulling system. Labor- and time-consuming repair work is eliminated because this cable pulling system is almost break-free. The RP5 is available in lengths of 20 m and 30 m. The RP5 replacement tape 40 m cannot be stored in the box.
Optimal area of application: for pipes with a diameter of 16 mm - 40 mm.
Application film: you can watch a short, very informative application film by scanning the QR code or at www.runpotec.com
Scope of delivery: 1 x RP5 cable pulling system Ø 5.5 mm including meter counter in plastic box, length 30 m, including 2 x RG7 - guide tip with twist compensation (pressed on both sides)
Type: 10203