Busch Jaeger 2TMA310010B0001 SD/U12.55.11-825 display 6,1 cm ( 2,4 inch ) for Busch-balance® SI content_copy

Busch-Trevion® Display 2.4', for Busch-balance® SI
Freely programmable touch panel with a 2.4-inch IPS screen with a resolution of 240*240, which enables the control and monitoring of the free@home or KNX system.
Control, monitor and manage your entire installation on one device:
switching - dimming - slider - blind - RGBW control element - step switch - scene switch - display element - audio control element.
The display contains a brightness and proximity sensor.
Operation is supported with haptic feedback.
The display contains an integrated temperature controller (RTC) with integrated temperature sensor.
A remote sensor (e.g. 6226/T / PT1000) for temperature detection can optionally be connected to the rear input.
An additional 24VDC power supply (e.g. 6358-101) is required for operation.
KNX:
Up to 12 operating pages with up to 12 operating elements can be created.
A maximum of 1..4 touch surfaces are possible per page.
10 scene actuators, 10 logic functions,
10 presence simulations and time programs,
18 fault and alarm messages.
The primary function enables direct operation of a function when touching the display.
The rear input can also be used as a binary input as an alternative to the remote sensor
free@home:
Up to 16 operating functions can be created on up to 4 pages.
A maximum of 4 touch surfaces are possible per page.
The scene function, logic functions, presence simulation and time programs are provided in free@home by the System Access Point and are not required in the display.
Fault and alarm messages are displayed as a 'pop up'.
The rear input can be used to connect a remote sensor (e.g. 6226/T / PT1000)

General
Other bus systems	free@home
Mounting method	Flush mounted (plaster)
Display	Other
Colour	Other
Degree of protection (IP)	IP20
Bus system KNX
Bus connection included

---