General
Model	On/Off
Type of power supply	230 V AC
Thermal feedback	None
Control characteristic	PI
Number of heater outputs	1
Number of cooler outputs	1
Sensor/feeler type	Resistance sensor
Mounting method	Flush mounted (plaster)
Max. contact voltage	230 V
Max. contact load	16 A
Degree of protection (IP)	IP20
Colour	Other
Contact type	Normally open contact (NO)
With receiver
External sensor
Heating
Adjustable differential
Temperature readable
With sound indicator
With display
With tap water circuit
Explosion-proof
IFTTT support available
Suitable for cooling
Suitable for heating

System 3000 room temperature controller insert with sensor connection - Switching electric underfloor heating and thermal actuators. - Output signal: pulse width modulation (PWM) or two-point control (on/off). - Input for switching to cooling mode. - Interrupts the heating process after 60 minutes (overheating protection of a heater). - Connection of a remote sensor (accessory) possible. Combination with RF operating top 1-way / 2-way for KNX: - Heating actuator 1-way - Sensor channel 1-way or 2-way. - Local control of the System 3000 insert possible. - Radio control of other devices for KNX as a sensor possible. - Temperature detection. - {b}Function selection of the insert for room temperature controller:{\b} Control of 230 V actuators, heating, cooling mode, heating and cooling mode, switching of heating or cooling mode via communication object or extension input. PWM and 2-point controller, absolute and relative setpoint specification, heat demand control including cascading, valve protection function. Cyclic monitoring of the floor temperature, service mode for valve output, frost protection function (automatic or via communication object), calibration of the temperature sensor, boost function, summer and winter compensation. Extension input is used to switch between heating and cooling mode.