Further information for Dold 0053511 BL5903.22/00000 AC230V safety relay
Technical data
1- / 2-channel
1, 2
Cat. / PL acc. to EN ISO 13849-1
4/e
Connection
Pluggable screw terminals
Output contacts max.
3 NO contacts
SIL CL acc. to IEC/EN 62061
3
SIL acc. to IEC/EN 62061
3
Thermal current Ith max.
5 A
Width
90 mm
Type
BL 5903
Cross fault detection
Variant
Contact equipping
2 NO contacts, 1 NC contact as signal output
Nominal voltage
AC 230 V
Approvals and Markings
TÜV, UKCA
Variant
Für 2-kanaligen Anschluß von einem Not-Aus-Taster
The Dold safety relay BL5903.22/00000 AC230V is an emergency stop module for industrial applications, used for the safe control of machines and plants. It is specifically designed for use in systems that automatically restart after power restoration following a power failure, for example in compressor controls or in water and wastewater technology. The device enables 2-channel connection of an emergency stop pushbutton and stores the actuation of the emergency stop pushbutton to ensure a safe shutdown. Upon restoration of mains voltage, the plant is automatically switched on again, provided the emergency stop pushbutton has not been activated.
Applications
This safety relay is intended for use in plants that must meet high safety requirements. It is particularly used in process and factory automation, where safe shutdown in the event of a fault and automatic restart after a power failure are important. Application areas include, for example, pump controls, compressed air systems, conveyor systems, and other industrial machines, where uncontrolled restart after a power failure must be avoided.
Functions and equipment in detail
The device features contact configuration with 2 NO contacts and 1 NC contact as alarm contact. The output contacts enable control of up to three NO contacts, allowing multiple loads or safety functions to be switched off in parallel. The feedback loop enables external contact amplification, increasing flexibility when integrating into existing control systems. LED indicators for channel 1 and 2, as well as for fault diagnosis, support visual monitoring of the operating status and facilitate troubleshooting.
Technology explained simply
The safety relay operates with a rated voltage of AC 230 V and is designed for use in 1- and 2-channel systems. Connection is made via removable screw terminals, enabling flexible and secure connections. The terminals are designed for conductor cross-sections of 2 x 1.5 mm² stranded wire with sleeve and plastic collar according to DIN 46228-1/-2/-3/-4 or 2 x 2.5 mm² stranded wire with sleeve according to DIN 46228-1/-2/-3. Cross-section detection, as well as wire break and line break detection on all inputs, ensure high reliability and prevent malfunctions due to defective connections. The thermal current Ith max. is 5 A, defining the contact load capacity.
Compatibility and accessories
The module is designed for 2-channel connection of an emergency stop pushbutton and can be used in systems requiring redundant safety functions. The specifications refer exclusively to the functionality of the module itself.
Mounting and installation
Mounting is carried out in standard control panels with a mounting width of 90 mm. The removable terminal blocks facilitate installation and maintenance. The connection terminals are designed to ensure a secure and durable connection even under mechanical stress. The device indicators support installation by providing visual feedback on the operating status.
Advantages in operation
The safety relay offers high safety integrity with Performance Level (PL) e and Category 4 according to EN ISO 13849-1, as well as Safety Integrity Level (SIL CL) 3 according to IEC/EN 62061. TÜV and UKCA certifications confirm compliance with European safety standards. The automatic restart after power failure, combined with storage of emergency stop actuation, reduces operating effort and increases plant availability. Integrated fault indication via LED indicators enables quick diagnosis and maintenance.