Versatile outdoor mast light in a reduced, international design language and flat construction. With intelligent label for quickly accessing luminaire information using a QR code. Large version, length of luminaire head 680 mm. In combination with the mast attachment, which must be ordered separately, can be used as a mast-top luminaire (spike size Ø 76 mm / Ø 60 mm, Jovie Z MB D...) or mast-side luminaire (spike size Ø 42 mm / Ø 60 mm, Jovie AZ MB D...). The inclination of the luminaire head can be adjusted in 4 ways. (0° / 5° / 10° / 15°). In MLT version (multi-lens technology), consisting of highly efficient, UV and temperature-resistant lens systems in a quadruple arrangement. Asymmetrical wide-beam light distribution for lighting streets according to M lighting classes with a street width to light point height ratio of up to 1.7. Additional beam characteristics are available for flexible adaptation to customer-specific lighting tasks. The light source can be replaced by qualified personnel. The LED system consists of MLT LED modules, each with 4 LEDs. Number of modules: 12. Rated luminous flux 15,000 lm, rated power 128.0 W, luminaire luminous efficacy 117 lm/W. Luminaire with adjustable luminaire luminous flux, reduction of up to 50%, using an app and NFC (Near Field Communication). The upper limit of the luminaire is set when delivered. Lowest adjustable luminaire luminous flux 15,000, highest adjustable luminaire luminous flux 15,000, lowest rated power 128.00, highest rated power 128.00. Luminaire luminous efficacy 117. Power factor ¿ 0.95. Efficiency version with material-optimized number of LEDs. General color rendering index (CRI) > 70, correlated color temperature (CCT) 4000 K. Other LED light colors available on request. Average rated service life LCLO (tq 25 °C) 100,000. The light source is replaceable in accordance with the ecodesign requirements (Regulation (EU) 2019/2020). Luminaire body made of die-cast aluminum. Color DB703 anthracite. Coating suitable for marine weather on request. With PMMA cover lens, printed. Cover lens can be individually printed on customer request. Visible label protected against the effects of weather behind the cover lens on request. Protection class (EN 61140): 02, protection type (DIN EN 60529): 66, impact resistance degree according to IEC 62262: IK09. Mast available on request. Wind attack area Fw (m²) = 0. Weight: 8.9 kg. The luminaire is connected without opening the luminaire body using the connecting cable that runs out to the outside. The operating device can be replaced by qualified personnel. Length of the connecting cable: 12 m. With electronic operating device, digitally dimmable (DALI). Configurable ballast with constant luminous flux (CLO). Connected load at the end of the service life: 134.00 W. Operating device in accordance with the DALI-2 standard (EN 62386). The operating device is replaceable in accordance with the ecodesign requirements (Regulation (EU) 2019/2020).The luminaire meets the requirements of the applicable EU directives and the Product Safety Act (CE marking). It is also ENEC-certified by an independent testing center. Surge voltage resistance differential mode / common mode: 6 kV / 10 kV. The luminaire meets the requirements of EN 60598 and is designed for wind effects in accordance with EN 1991 (Eurocode) with a base wind speed of up to 30 m/s (corresponds to wind zone 4 in Germany) in terrain category 1. This takes into account a snow load (up to 1 kN/m²) and icing (up to 2 cm) at a light point height in accordance with the installation instructions. Exposed locations (e.g. bridges, installation on buildings or directly next to railway tracks) are not taken into account. Impact loads are not taken into account.