Versatile outdoor mast light in a reduced, international design language and flat construction. With intelligent label for quickly calling up luminaire information using a QR code. Compact design, length of luminaire head 450mm. In combination with the mast attachment, which must be ordered separately, it can be used as a mast-top luminaire (spike size Ø 76 mm / Ø 60 mm, Jovie Z MB D...) or mast-side luminaire (spike size Ø 42 mm / Ø 60 mm, Jovie AZ MB D...). The inclination of the luminaire head can be adjusted in 4 ways. (0° / 5° / 10° / 15°). In MLT design (multi-lens technology), consisting of highly efficient, UV and temperature-resistant lens systems in a quadruple arrangement. Asymmetrical wide beam light distribution for lighting streets according to P lighting classes and M lighting classes with a street width to light point height ratio of up to 2.0. Other beam characteristics are available for flexible adaptation to customer-specific lighting tasks. The light source can be replaced by qualified personnel. The LED system consists of MLT LED modules with 4 LEDs each. Number of modules: 4. Rated luminous flux 4,200 lm, rated power 36.0 W, luminaire luminous efficacy 116 lm/W. Luminaire with adjustable luminaire luminous flux, reduction of up to 50%, using app and NFC (Near Field Communication). The upper limit of the luminaire is set when delivered. Lowest adjustable luminaire luminous flux 4,200, highest adjustable luminaire luminous flux 4,200, lowest rated power 36.00, highest rated power 36.00. Luminaire luminous efficacy 116. Power factor ¿ 0.90. Efficiency version with material-optimized number of LEDs. General color rendering index (CRI) > 70, correlated color temperature (CCT) 4000 K. Other LED light colors available on request. Average rated service life LCLO (tq 25 °C) 100,000. The light source is replaceable in accordance with the ecodesign requirements (Regulation (EU) 2019/2020). Luminaire body made of die-cast aluminum. Color DB703 anthracite. Coating suitable for marine weather on request. With PMMA cover lens, printed. Cover lens can be individually printed on customer request. Visible label protected against the effects of weather behind the cover lens on request. Protection class (EN 61140): 02, protection type (DIN EN 60529): 66, impact resistance level according to IEC 62262: IK09. Mast available on request. Wind attack area Fw (m²) = 0. Weight: 4.7 kg. The luminaire is connected without opening the luminaire body using the connecting cable that runs out to the outside. The control gear can be replaced by qualified personnel. Length of the connecting cable: 8 m. With electronic control gear, digitally dimmable (DALI). Configurable ballast with constant luminous flux (CLO). Connected load at end of service life: 38.00 W. Control gear in accordance with DALI-2 standard (EN 62386).The operating device is replaceable in accordance with the ecodesign requirements (VO (EU) 2019/2020). The luminaire meets the requirements of the applicable EU directives and the Product Safety Act (CE marking). In addition, it is ENEC-certified by an independent testing center. Surge voltage resistance differential mode / common mode: 6 kV / 10 kV. The luminaire meets the requirements of EN 60598 and is designed for wind effects according to EN 1991 (Eurocode) with a base wind speed of up to 30 m/s (corresponds to wind zone 4 in Germany) in terrain category 1. This takes into account a snow load (up to 1 kN/m²) and icing (up to 2 cm) at a light point height in accordance with the installation instructions. Exposed locations (e.g. bridges, installation on buildings or directly next to railway tracks) are not taken into account. Impact loads are not taken into account.