General
Maximum data transfer rate	10 Gbit/s

The NetXpert XG2 from Softing IT Networks is a performance tester for network and cabling qualification, specifically developed for copper cabling and optionally supporting fiber optic tests. The device is used for installation, commissioning, and troubleshooting in networks and enables tests up to a transmission rate of 10 Gbit/s. It combines passive and active testing methods to perform a comprehensive analysis of cabling quality and network functions.

Applications
The NetXpert XG2 is used in IT infrastructure installation and maintenance, particularly for qualifying copper cabling in the 10 Gbit/s range. It is suitable for testing networks in enterprises, buildings, and for the maintenance of IT systems. The functions include both passive cabling testing and active network tests that verify the functionality of connected devices.

Functions and Equipment in Detail
The device performs passive tests to check the IEEE compliance of copper cabling. This includes analysis of the wiring map, Bit Error Rate Test (BERT), measurement of the signal-to-noise ratio (SNR), and determination of length and delay differences (Delay Skew). These methods enable precise diagnosis of cabling faults. Additionally, cable lengths and distances to breaks or short circuits are displayed.

Technology Explained Simply
The combination of four measurement methods – wiring map, BERT, SNR, and Delay Skew – ensures high reliability of test results. The Bit Error Rate Test checks data integrity by recording the number of erroneous bits during transmission. The signal-to-noise ratio measures signal quality relative to background noise, which is crucial for connection stability. Delay Skew detects timing differences between individual conductors, which is critical at high transmission rates. Results are displayed directly on the device and can be generated as a PDF report.

Compatibility and Accessories
The NetXpert XG2 supports active network tests on copper, fiber optic, and WLAN. This includes testing connection status, DHCP tests, Network-Discovery, PoE tests (up to 90 W), Ping lists, Traceroute, VLAN detection, and support for IPv4 and IPv6. The device also detects CDP and LLDP protocols to identify network components.

Mounting and Installation
The device is used as a handheld unit and requires no special mounting. It is directly connected to the cabling to be tested. The delivery includes an XG2 handheld unit for copper and active fiber optic, a remote unit (copper only), two RJ45 Cat 6A patch cables, a USB adapter, two power supplies, a hard-shell case, a manual, and a 4-cell battery. Tests can be performed with or without external power supply.

Advantages in Operation
The integrated PDF report generation enables documented and verifiable testing. The combination of passive and active tests provides a comprehensive analysis, checking both physical cabling and network functions. Support for PoE up to 90 W and LLDP protocol detection expands application possibilities in modern networks. The devices are designed for professional use and offer high reliability in fault diagnosis.