Further information for Netgear AXC761-10000S CABL SFP+ 1 m
Features
Cable length
1 m
Connector 1
SFP+
Connector 2
SFP+
Connector 1 gender
Male
Connector 2 gender
Male
Connector contacts plating
Silver
InfiniBand protocol
Logistics data
Harmonized System (HS) code
84733080
The Netgear AXC761-10000S is a Direct-Attach cable with SFP+ connectors at both ends, specifically designed for use in network systems with 10 Gigabit Ethernet (10GE). It serves as a connection element between compatible switches and enables a stable, cable-based connection over a length of 1 metre. The cable is designed as a copper cable (10GSFP+Cu) and supports data transmission according to the 10 Gigabit Ethernet standard. The connection is made via SFP+ connectors, which are implemented as plugs on both sides, allowing it to be directly inserted into the corresponding SFP+ ports of the network devices.
Applications
The cable is primarily intended for use in stacking systems, where multiple switches are connected to enable centralized management and higher port density. It is specifically developed for models such as XSM7224, GSM72xxPS, GSM7328S, GSM7328FS, GSM7352S, RN12S0620, and RN12S1220, which feature SFP+ ports. Using this cable in such systems ensures high bandwidth and low latency, which is essential for critical network environments in enterprises and data centres.
Functions and Features in Detail
The cable features SFP+ connectors at both ends, implemented as plugs. The contacts of the connectors are silver-plated, ensuring good electrical conductivity and corrosion resistance. The cable length is exactly 1 metre, making it ideal for short connections within a rack or between adjacent devices. The construction as a Direct-Attach cable means it can be used directly between two devices without additional amplifiers or converters.
Technology Explained Simply
The cable uses SFP+ technology, developed for high-speed connections in the 10 Gigabit Ethernet range. The designation 10GSFP+Cu indicates that it is a copper cable designed for 10 Gigabit Ethernet. The connection is made via the SFP+ ports of the switches, located on the front panel of the devices. The silver-plating of the contacts ensures a reliable electrical connection and minimizes contact resistance. The cable length of 1 metre is suitable for use in standard rack environments, where devices are mounted in close proximity.
Compatibility and Accessories
The cable is intended for a range of Netgear switch models, including XSM7224, GSM72xxPS, GSM7328S, GSM7328FS, GSM7352S, RN12S0620, and RN12S1220. These models feature SFP+ ports into which the cable can be directly plugged. Compatibility is limited to devices equipped with corresponding SFP+ connectors. It is not intended for optical connections or other protocols such as InfiniBand, although sources mention support for the InfiniBand protocol — this is not relevant in the context of its primary use as a stacking cable.
Installation and Mounting
Installation is performed by simply inserting the SFP+ plugs into the corresponding ports of the switches. No additional tools or configurations are required. The connection becomes active immediately once the plugs are correctly inserted into the ports. The cable length of 1 metre requires the devices to be in close proximity, ideally mounted in the same rack or adjacent to each other.
Operational Advantages
The cable offers a high data transfer rate of 10 Gigabit per second and is suitable for use in critical network environments. The use of copper cables enables a cost-effective and reliable connection without requiring additional components such as optical transceivers. The silver-plating of the contacts ensures long service life and a stable connection, even under high loads. The direct connection between switches reduces latency and increases network efficiency.