The high-quality motion sensor can be trained into your LUPUS XT control center with just one click. If the detector is active, it registers every movement within milliseconds. This means you are always informed and alerted in an emergency. This way you can secure the interior of your home, shop or office building.
Correctly mounted at a height of 1.8 - 2 meters, it detects objects at a maximum of 12 meters and at an angle of 110 degrees.
The PIR motion detector V2 is battery-operated, has sabotage detection on the back and is connected to the alarm system via radio. Therefore it can easily be glued or screwed to any wall or ceiling of your choice. A corner bracket and mounting material are included in the scope of delivery. Cables for signal transmission or a power supply via power supply are not necessary. Simply connect the motion detector to the alarm system via the control center and set it up.

Highlights

• Reliably reports all moving objects using thermal radiation
• Radio connection (approx. 30 - 100 m range)
• Small, modern housing
• Sabotage detection
• Status transmission
• Alerting in the event of an alarm via the control center via SMS, telephone call, push, email or Contact ID

Product type

• sensor/actuator
• ear category (ElektroG): relevant, category 5: small devices < 50 cm (all pages), small devices B2C

data transmission

• radio standard: ZigBee

basic properties

• color: white
• height: 94 mm
• Length/depth: 45 mm
• Width: 62 mm

Scope of delivery

• LUPUSEC PIR motion detector V2
• Battery (3 V CR123 lithium battery)
• Screws and dowels
• Corner bracket
• Manual