The LUPUSEC water detector reliably alerts you in the event of water damage or flooding. To do this, simply place the water detector on the floor (e.g. near the washing machine). Alternatively, you can connect an external sensor using a cable and attach it so that only it has contact with the ground. The detector itself can therefore also be mounted on the wall. Any contact with water activates a siren built into the detector and sends an alarm to the control center.
The water detector is also battery-operated and is connected to the alarm system via radio. Therefore, it can be installed close to the floor in any room. Cables for signal transmission or a power supply via power supply are NOT necessary. Simply connect the water detector to the alarm system via the control center and set it up.

Highlights

• Reliably reports water upon contact
• Protects against water damage
• Easy to install
• Waterproof sensor (cable)
• Additional sensor on the underside of the housing
• In the event of an alarm, alerting via the control center via SMS, (telephone call), email and contact ID

Product type

• sensor/actuator
• ear category (ElektroG): relevant, category 5: small devices < 50 cm (all sides), small devices B2C

Data transmission

• radio standard: ZigBee

Basic properties

• Color: white
• Height: 95 mm
• Length/ Depth: 82.5 mm
• Width: 29.5 mm

Scope of delivery

• Water sensor
• CR123A 3V lithium battery
• Screws and dowels
• Manual