Further information for Lapp 221807/76 ÖLFLEX TRAY II 7G1,0 18AWG control cable
General
Number of conductors
7 piece
Wire identification
numbers
Degree of protection
Flexible
Approval
UL listed
Application
control cable
Temperature range
-25 °C °C
Application range
Interior and exterior area
Direct burial
in the USA
Torsion application
wind turbines
Installation
open on cable trays
Certification
multi-certification
Oil resistance
Flame retardancy
The control cable ÖLFLEX® TRAY II 7G1, type 18/7C, manufacturer's number 221807/76, is produced by Lapp and designed for use in industrial plants and machines. It is suitable for wiring internal machine and cross-plant control circuits and is intended for fixed installation as well as occasional movement. The cable is specifically developed for use in the USA, features UL certification, and thus enables use in the North American market. At the same time, it is universally applicable in Europe, supported by multi-certification, which reduces part variety. The flexible construction allows for easy and cost-saving installation, as additional cable protection systems can be omitted.
Applications
This control cable is suitable for moderate mechanical stress and can be used in dry, damp, and oily environments. It is suitable for outdoor use in both the USA and Europe, provided the temperature range is observed. In the USA, it is also approved for direct burial. A special application field is its use in torsion applications in wind turbines, where the cable meets specific requirements for flexibility and load capacity. Installation is done openly on cable trays without protective conduit, simplifying the process.
Functions and Equipment in Detail
The cable features conductor identification by numbers, which facilitates assignment and wiring during operation. The construction is oil-resistant and flame-retardant, enhancing safety in industrial environments. The flexible structure allows movement under occasional mechanical loads without impairing electrical conductivity. Use in oily environments is possible due to special materials that offer high resistance to mineral oils and other lubricants.
Technology Explained Simply
The ÖLFLEX® TRAY II 7G1 control cable is a flexible control cable with 7 conductors, each 1.0 mm² cross-section (equivalent to 18 AWG). UL certification ensures compliance with North American safety standards, particularly for use in industrial and machine tools. The flame-retardant property reduces fire risk in case of short circuits or overloads. The oil-resistant insulation protects the conductors from chemical degradation caused by lubricants and coolants. The flexible structure allows movement under occasional mechanical loads without impairing electrical conductivity.
Compatibility and Accessories
The cable is suitable for use in various industrial plants, particularly in machine building, machine tools, and wind energy installations. Multi-certification enables universal use in Europe and the USA, simplifying logistics and ordering processes. Installation is done openly on cable trays, eliminating the need for additional protection systems. The cable is suitable for torsion applications in wind turbines, expanding its application range in renewable energy technology.
Installation and Mounting
Installation is performed by open routing on cable trays, with no protective conduit required. The flexible structure facilitates bending and routing, especially in confined spaces or complex routing paths. Conductor identification by numbers supports correct assignment during wiring. The cable can be installed in dry, damp, and oily environments, provided temperature limits are observed. Direct burial is permitted in the USA, subject to local regulations.
Operational Advantages
The control cable offers high reliability in industrial applications due to its oil-resistant and flame-retardant construction. Multi-certification enables universal use, reducing part variety and lowering logistics costs. The flexible structure and open installation on cable trays without protective conduit result in simple and cost-effective installation. Suitability for torsion applications in wind turbines expands application possibilities in renewable energy technology. The cable is suitable for outdoor use, provided temperature limits are observed, and can be used in oily environments without impairing electrical properties.