LANsmart is the multi-functional cable tester for technicians and professionals. The LANsmart provides the basic information about the tested network cable such as open, shorted, mis-wired and split pairs. The LANsmart discovered and localized these errors and displays the results in an easy-pin-to-pin display on. In addition to these basic functions, the location of the fault on the basis of the length measurement. By the TDR technology (Time Domain Reflectometer) is a length measurement. The einzelenen pairs of the cable are measured, and the length is displayed. If one such cable is short-circuited, so the length of the wire pair is shorter and one is Fehlerlokation possible. With the Port Finder function that are connected to a hub or switch cable can be indentifiziert. This is especially important when wiring'' inherited'' a time-saving feature! If the cables have been laid, without which they are connected to a hub / switch, the Tone Generator can send an audio signal through the cable, which can be found with a sample. - testing for open, short, incorrectly wired and split pairs - Length measurement by TDR technology for UTP / STP cable - Port Finder function - Tone Generator function for each individual wire or the entire cable - displays test results on a clearly arranged LCD display - Compatible with all cables the Cat. 3/4/5 and 6 (!) LANsmart is the multi-functional cable tester for technicians and professionals. LANsmart provides the basic information about the tested network cable such as open, shorted, mis-wired and split pairs. The LANsmart discovered and localized these errors and displays the results in an easy-pin-to-pin display on. Besides these basic functions the location of the error based on the length measurement. By the TDR technology (Time Domain Reflectometer) is a length measurement. The einzelenen pairs of the cable are measured, and the length is displayed. If a cable is as short as the length of the wire pair is shorter and a Fehlerlokation is possible. Finder function With the port connected to a hub or switch cable can be indentifiziert. This is mainly due to inherited wiring a time-saving feature! If the cables have been laid, without which they are connected to a hub / switch, the Tone Generator can send an audio signal through the cable, which can be found with a sample.