General
Mounting method	Floor installation
Type of cover	Door
Cover model	With notch
Type of door	Single
Nominal current (In)	1600 A
Height	2000 mm
Width	600 mm
Depth	600 mm
Internal depth	596 mm
Plate thickness cabinet	2 mm
Plate thickness door/cover	2 mm
Colour	Grey
RAL-number	7035
Number of openings for flange plates	4
Number of conduit inlets	6
Material housing	Steel
Surface protection	Powder coating
Degree of protection (IP)	IP41
Protection class	I
Impact strength	IK10
Circuit integrity	None
Transparent cover/door
With lock
Extension possible
With mounting plate
Suitable for outdoor use
Suitable for lightning protection

Modular distribution board IP41 600x2000x600 120° RAL7035 rear wall galvanized. Modular cabinet for indoor installation in accordance with VDE 0660 Part 600-1/-2, DIN EN 61 439-1/-2, dimensions in accordance with DIN 43870 protection class, IP 41 in accordance with DIN EN 60529 (VDE0470-1), protection class IP 3x with open door, air and creepage distances in accordance with VDE 0110, Part 1 and 2/1.89, rated insulation voltage AC 800 V, overvoltage category IV, pollution degree 3, insulation class II, protection class I earthed. Floor-standing housing for single or row installation with removable rear and side walls, width 1 to 6 fields, 144 to 864 space units. Interior fitting system can be installed for network systems: 3 AC 50 Hz 230/400 V or 3 AC 50 Hz 400/690 V with a maximum feed-in current of 1600 A.
Cabinet frame made of galvanized sheet steel, cover plate and rear wall made of hot-dip galvanized sheet steel. With horizontal support rail for supporting rail stabilization, coupling plates for supporting rail fastening, prepared for univers N interior fitting system. Busbar bushings can be flanged next to each other through open side walls.
Door made of 2 mm sheet steel, powder-coated and baked, surface-mounted with internal hinges, can be hinged on the right or left. Door opening angle 120°, double door from width 1100 mm, door lock with standard four-point rod lock (single door) or 3-point rod lock (two doors) with 3 mm double bit.
Upper cable entries: 2 rows are punched out in the cover plate for each field, different cable entries (plastic or metal) can be installed. Lower cable entries: open, base plate with brush can be installed. Compliance with the protection class is required for installation of the cable entries at the top/bottom.
Note: Matching side walls and skirting boards are available as accessories. Door lock can be exchanged for other locks.