eNet wireless switching or touch actuator 8-way blind actuator 4-way REG Features: Can be set with eNet server: Fully encrypted radio transmission (AES-CCM) from eNet server software version 2.0. Operating locks. Update of the device software. The eNet wireless switching or touch or blind actuator receives telegrams for switching lighting or controlling electrically operated blinds from the eNet wireless receiver module or eNet server via a data line. Two outputs are operated in the same operating mode (switching, button, blind or roller shutter). Switching of lighting or single-phase fan motors. Control of electrically operated blinds, such as blinds, roller shutters or awnings. Operating modes: Switch actuator, touch actuator per output or blind actuator, roller shutter actuator can be set for outputs in pairs. Status feedback to eNet radio transmitter. Scene operation. Button operating mode: Relay contact remains closed as long as telegrams are received (max. 60 seconds). Positioning of blinds and slats via scene call-up. Positions for sun protection and twilight can be saved. Threshold scenes for sun protection, twilight and wind alarm. Blind running time can be saved. Slat reversal time can be saved. Can be set with eNet server: Flashing function. Follow-up time. Switch-on or switch-off delay. Switch-off warning. Minimum switching repeat time. Permanently on, permanently off. Reversal time when changing direction. Direction of travel can be inverted (e.g. for roof windows). Position for sun protection, twilight, lock-out protection and wind alarm. Notes: An eNet radio receiver module or an eNet server is required to operate this DIN rail-mounted device.