RF wall transmitter 2-way for KNX anthracite - The wall transmitter can be attached to walls using screws or stuck to smooth or transparent surfaces using a mounting plate. - Planning, commissioning and parameterization are carried out using ETS (version 5 or newer). - Integrated USB Micro Type B interface for local programming and can be used as a KNX RF interface. - Battery-operated device. - Device supports KNX Secure. 'Switching' function: - Command can be parameterized when pressed and released (ON, OFF, TOGGLE, no reaction). - Command when the button is pressed for a short or long time. 'Dimming' function: - Command can be parameterized when the button is pressed (brighter-ON, darker-OFF, brighter/darker-TOGGLE). 'Blind' function: - Command can be parameterized when the button is pressed (UP, DOWN, TOGGLE). 'Value transmitter' function: - 1 byte, 2 bytes, 3 bytes, 14 bytes ASCII. 'Color' function: - Color control RGB/RGBW, toggling of 8 color values. 'Scene extension' function: - Scene recall and saving possible, toggling of 8 scenes. 'Individual' function: - Various function combinations when button is pressed or released. - With scene extension: storage function possible. Installation on device box or on smooth, flat surfaces by screwing or gluing. Using metal cover frames can lead to a reduction in range. Batteries are consumables and must be replaced regularly. Please observe the regulations for the disposal of used batteries. Batteries are included in the scope of delivery. Radio wall transmitter, mounting plate, adhesive film (privacy protection for glass surfaces) and adhesive dots for installation on smooth, flat surfaces are included in the scope of delivery.