Eltako 61100001, EAN: 4010312107911

Eltako ESR61NP-230VUC - surge relay 8 230V UC 10A 1S 61 100 001 ESR61NP 230VUC

Installation > Modular devices / equipment installation > Impulse switch / relay

Eltako ESR61NP-230VUC - surge relay 8 230V UC 10A 1S 61 100 001 ESR61NP 230VUC

Lieske Part No.137915
Mfg Part No61100001
EAN-Code4010312107911
Manufacturer Eltako
Here only 57,52 EUR
68,45 EUR incl. VAT

Further information for Eltako ESR61NP-230VUC - surge relay 8 230V UC 10A 1S 61 100 001 ESR61NP 230VUC

1 normally open contact, not potential-free, 10A/250V AC, 230V LED lamps up to 600W, incandescent lamps 2000W. Delayed release with switch-off warning and permanent light with push-button can be activated. Standby loss only 0.7 watts. For flush mounting. 45mm long, 45mm wide, 18mm deep. Contact switching at zero crossing to protect the contacts and lamps. The latest hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. By using a bistable relay, there is no coil power loss and no heating as a result, even when switched on. After installation, wait for the automatic short synchronization before connecting the switched consumer to the mains. Control voltage 230V, additionally with galvanically isolated universal control voltage 8..230V UC. Supply and switching voltage 230V. Very low switching noise. Time setting up to 120 minutes in the ESV function. Buttons with a glow lamp current of up to 50mA can be connected to the control input. If the supply voltage fails, the device is switched off in a defined manner. If the delay time is set to minimum in the ESV function, the release delay is switched off and the normal impulse switch function ES is used. Can be switched to the ER switching relay function. No glow lamp current is permitted in the ER function and only control input A1-A2 should be used. The ER function is also suitable for feedback with the switching voltage of a dimmer switch. If the switch-off pre-warning is switched on, the lighting flickers starting around 30 seconds before the time expires and a total of 3 times at increasingly shorter intervals. If the button permanent light is switched on, you can set the light to permanent by pressing the button for longer than 1 second, which switches off automatically after 2 hours, or can be switched off by pressing the button for longer than 2 seconds. If the switch-off pre-warning and button permanent light are switched on, the switch-off pre-warning only occurs after the permanent light is switched off.
This is an offer of:

Lieske Elektronik e.K.

Reutener Str. 10
79279 Vörstetten

http://industry-electronics.com
Tel. 07666/88499-0
Fax. 07666/88499-111

Diesen Artikel finden Sie unter:
industry-electronics.com/artikel/137915
qrcode für Eltako ESR61NP-230VUC - surge relay 8 230V UC 10A 1S 61 100 001 ESR61NP 230VUC