Powerline TLZ actuator with 1 channel. 53x43mm, 25mm deep, for installation in 58mm switch boxes. Release delay from 1 minute to 120 minutes. Switch-off warning adjustable. 1 normally open contact not potential-free 10A/250V AC, light bulbs 2000 watts. Sensor input 230V. Standby loss only 0.5 watts. For controlling and switching in the same place. There are two rotary switches on the front for address assignment: The left rotary switch determines the group address g with 16 alphabetical values from A to P. The right rotary switch determines the release delay time. Above this there is a slide switch as a configuration switch with positions 0, 1 and 2. Position 0: Button on the sensor input with follow-up switching. Position 1: Like position 0, but with switch-off warning. Position 2: A changeover switch is evaluated like a button. All entries and configurations can be accessed via the Sienna Professional PC software, even via the power supply. To the left of the rotary switches there is a red LED that shows all activities. Next to it is the reset button and to the right of it a service pin. Functions as per the operating instructions. The connection terminals at the top are plug-in terminals for conductor cross-sections from 0.2mm² to 1.5mm².