The SI system (current pulse system) is a control and automation technology for hard-wired installations. The wide range of functional modules and the logic provided by the wiring enables a wide range of control tasks to be carried out. These include switching electrical consumers (e.g. lights, roller shutters, blinds) depending on the light and time of day, dimming functions for low-voltage and DALI lights, or protecting roller shutters and awnings from wind and rain. These can be supplemented as required with individual, group and central commands. The SI system does not require any PC programming and can therefore be installed conventionally. Since the wiring largely corresponds to controls with relay or contactor circuits, the costs for planning and commissioning are very low. The consistent use of the control and supply voltage of 24 V DC and the strict separation between the protective extra-low voltage and low-voltage side make the components compact, cost-effective and immune to interference. In addition, control cables with a length of up to 100 m allow standard switch programs to be easily connected, even in large buildings. The system is particularly suitable for lighting control. Remote dimmers, the DALI gateway and twilight sensors are available for this purpose. Additional components make installation easier. The SIWH telescopic bracket makes it easier to install the SIWS wind sensor and SIRW rain guard. The bracket is extendable and the supplied mounting bracket helps to ensure the rain guard is at the correct angle. Properties: simultaneous accommodation of wind sensor and rain guard, supplied mounting plate for rain guard, large telescopic range, easy installation, mounting type: wall mounting, areas of application: the telescopic bracket is suitable for attaching the SIWS wind sensor and SIRW rain guard to building walls.