General
Assembly arrangement	Basic element
Type of load	Universal and LED Retrofit
Mounting method	Flush mounted (plaster)
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Suitable for degree of protection (IP)	IP20
Impact strength	IK00
Nominal voltage	230
Width of device	71
Height of device	71
Depth of device	54
Min. depth of built-in installation box	32
Halogen free
IFTTT support available

With rotary operation, pressure sequence changeover switch and soft locking. 2-wire connection technology (neutral conductor not required). Optimized for dimming retrofit LED lamps (LEDi). For dimmable retrofit LED lamps (LEDi). For dimmable retrofit LED lamps (LEDi) on conventional or electronic transformers For incandescent lamps, 230 V halogen lamps, low-voltage halogen lamps with conventional or electronic transformers and dimmable halogen energy-saving lamps. Mixed load operation of LEDi and conventional lamps possible. Can be switched between leading and trailing edge phase control using a selector switch. Low noise thanks to the use of MOSFET transistors. Short-circuit proof and overload proof (electronic fuse). With adjustable minimum brightness. Without central plate. Nominal voltage: 230 V~, + 10% / - 10% Nominal frequency: 50 Hz/60 Hz Nominal power: 2 - 100 W/VA (retrofit LED loads). Nominal power: 10 - 250 W/VA (non-LED loads). Can be illuminated using a glow lamp. Glow lamp included with the central plate. For conventional transformers, take into account ~20% transformer losses. For electronic transformers, take into account ~5% transformer losses.