Professional LCD resin. The printing efficiency with this resin is higher than market compatible DLP/LCD/SLA resins. This resin is only intended for printers with an LCD screen. Do not use for DLP or SLA machines! High speed curing. This resin ensures the strength of the molded parts and prevents excessive shrinkage. Also improves printing speed and curing time and improves the printing efficiency of LCD printers. Strong adhesion of the model during printing and easy release afterwards. Not only has a positive effect on the success rate when printing and on precision, but also minimizes the required release force afterwards. This makes it easier to remove the model attached to the print platform. The lower viscosity also enables easier cleaning of the machine and the model. The material is rigid and tough at the same time. A material that is too rigid can lead to fragmentation of the model in finished prints, and a material that is too flexible is susceptible to loss of printing accuracy and deformation. Our material combines both and thereby achieves first-class printing results. The resin remains stable and easy to store even under different climatic conditions. Information: Main material: resin monomer < photoinitiator Exposure parameters: lower exposure time(s) 20-60s,
normal exposure time(s) 5-15s Precautions:
Storage method: Protect from light and store at room temperature. (Sunshine contains a lot of UV light and solidifies the photosensitive resin.) It is recommended to store the resin at an ambient temperature of 15 to 35 ° C. The lower the temperature, the higher the viscosity of the resin. Sealed storage, excessive dust or moisture may affect print quality. Usage:Shake well before use. Avoid using resin in places with a lot of sunlight. When using resin, wear gloves to avoid direct skin contact and keep the room ventilated. In the event of accidental contact, clean with plenty of water as quickly as possible. If you feel unwell, see a doctor as soon as possible. Printed models: Use highly concentrated alcohol to clean the finished printed object (recommended concentration of 95% or more, the higher the better). Clean the object for around 30 seconds to achieve the best possible cleaning. Pour unused resin back into the original resin bottle. Also avoid leaving the resin in the tub for too long without use, as any resin contamination could affect a future print (without pouring the resin into airtight containers or sealing it with plastic wrap). The ANYCUBIC resin is best suited for the Anycubic Photon / Photon S.
The structure of the light source in the printer, the exposure time and other printing parameters of different manufacturers of 3D LCD printers are different. The composition ratio of the ANYCUBIC resin developed for the Photon is special and best matches the Photon printing parameters.