PrimeLine LED driver - dimmable with programmable current
350-700 mA / max. 37 W
Compact housing design with integrated strain relief,
suitable either as a built-in version or for independent operation.
Electrical properties
The LED modules can be switched on the secondary side (hot wiring).
Power factor at full load:

0.9

Standby loss: < 0.5 W
Dimming properties
Dimming is achieved via a PWM signal to the nominal current.
Dimming range: 1 to 100%
If no dimming signal is applied, the brightness is 100%.
Programmability
The output current can be freely programmed between 350 mA and 700 mA in 1 mA steps
(factory setting: 350 mA). The iProgrammer (order no. 186428) and a PC with the appropriate VS software
are required for programming . Connection properties Power supply: 220?240 V ±10 % Mains frequency: 50?60 Hz DC operation: 198?264 V DC, 0 Hz (reduction to 176 V possible with shortened service life) With integrated mains loop-through Plug-in terminals: 0.2?1.5 mm² Safety features Electronic short-circuit protection Overload and overtemperature protection Idle-proof Protection type: IP20 Protection class II SELV