NanoStation Loco M2 is a compact outdoor unit Which includes 2 x 8 dBi antenna (MIMO) for the 2.4 GHz band.The unit Allows real communication speed up to 150 Mbps.Another big advantage is (with addition to high transfer speeds thank tothe 802.11n standard) the TDMA Time Division Multiplexing Which Enables to connect more than 300 clients to the product so unit.This Has A low latency.Compared to two predecessors NanoStation M2 Loco Has A strongerprocessor clocked at 400 MHz and bigger memory.Web administration is very simple and transparent. Here are a few examples of what can be set: * AP mode, client or WDS * Traffic Shaping * QoS * transparent bridge or routing in between WAN and LAN, without NAT or NAT * trength of the signal, Which Shall CORRESPONDING to specific signaling LED * Output power to 23 dBmThe device supports IPv6 transparent transfers in the bridge and WDS mode.The package so Consists of the 24 V PoE power source, Which contains a reset button.You can use it for switching the device to the TFTP firmware recovery mode .another advantage is PoE support on the second Ethernet port for direct supply of another device.This feature can be disabled via the software adjustment.