Contact EPIC® POWERLOCK QCM 95 (1), Contact for design: Powerlock D6 C, , Source, Crimp connection, For cross-section (min./max.): 95mm² - 95mm², Silver-plated copper alloy, Areas of application: For use with unshielded single wires, Withstands medium mechanical loads, Can be used for mobile and stationary energy or emergency power supply by generators or battery storage, Suitable for three-phase and direct current applications The maximum current in conjunction with screw contacts is 400 A, the maximum current in conjunction with crimp contacts is 660 A, Suitable for electric motors and cooling units, Benefits: M12 threaded post contact for tubular cable lug contacting Contact sink for use with design A1, Contact source for use with design A6 (either screw or crimp depending on the application), Screw contact for service-friendly connection without special tools Screw contact sink for use with design F6 S, Screw contact source for Use with the D6 S design Screw contacts are intended for conductor cross-sections of up to 120 mm² For smaller conductor cross-sections up to 50 mm², reducing sleeves must be used to gradually reduce the diameter. Crimp contact ensures maximum contact reliability between contact and cable and creates a vibration-proof connection Different contact sizes available for conductor cross-sections from 35 - 240 mm² Crimp contact sink for use with the F6 C design, Crimp contact source for use with the D6 C design All contacts are supplied with a contact retaining pin for attaching the contact to the attachment housing