Benning CM 12 True RMS power current clamp multimeter. Digital display. Analogue bar display yes. 4-digit LCD display (9999 points). With screen backlight. Power analysis in single-phase, three-phase and DC networks. Current measuring range/DC 0.01 A - 600 A. Current measuring range/AC 0.01 A - 600 A. Current type direct/alternating current. True RMS measurement (TRMS) yes. Voltage measurement/AC 10 mV - 1000 V. Voltage measurement/DC 10 mV - 1000 V. Resistance measuring range 0.1 Ohm - 100 kOhm. Frequency measurement 0.01 Hz - 10 kHz. Frequency measurement yes. Capacitance measurement 0.001 µF - 4000 µF. Capacitance measurement yes. Active power measurement 1 W - 600 kW. Power factor cos phi 0.01 - 1.00. Continuity test/diode test. Extended current measuring range via optional flexible AC current clamp converter (300.0 A/ 3000 A AC). LOG function (9999 measured values). MEM memory (1000 measured values, A-SAVE). Bluetooth Low Energy 4.0 interface. Free IOS and Android APP (from 4.3). Download of LOG/ MEM. Measured value storage in CSV format. Low-pass filter (HFR) for measurements on motor drives. Volt sensor signals phase voltages/cable breaks in lines without contact (optical). Inrush current measurement INRUSH. Starting current of motors, lighting systems. THD measurement, total harmonic distortion of the harmonics. Phase rotation display. Manual/automatic measuring range selection. Automatic shutdown. Instantaneous value memory Hold. Maximum value memory MAX. Minimum value memory MIN. Peak value memory PEAK. Average value AVG. Clamp opening 33 mm. Measuring circuit category Cat IV. Max. voltage measuring circuit category 600 V. Measuring circuit category Cat III. Max. voltage measuring circuit category 1000 V. Includes case, 6 x 1.5 V Micro/ AAA batteries, test leads.