Measuring adapter for EV charging cables (Mode 2, Mode 3) and wall boxes. Testing of EV charging cables Mode 2 (emergency charging cable) and Mode 3 in combination with device tester BENNING ST 755+/760+ in accordance with DIN EN 50678 (VDE 0701) and DIN EN 50699 (VDE 0702). Testing of wall boxes in combination with installation tester IT 200/IT 130 in accordance with DIN VDE 0100-600 and DIN VDE 0105-100. Vehicle simulation (CP status (A, B, C, D)) and simulation of the current carrying capacity of the charging cable (PP status (NC, 13 A, 20 A, 32 A, 63 A)). Error simulation: short circuit diode, short circuit CP signal and PE open. LED displays for mains (L1/L2/L3-N) and vehicle side (L1/L2/L3-N). Testing of RPE, RISO, IPE/IBER, charging cable Mode 2/Wallbox (RCD 30 mA AC + 6 mA DC), charging cable Mode 3 (continuity, short circuit and rotating field). Mini USB interface for data exchange, device tester and firmware update. Connectors on infrastructure side: Type 2, CEE (16 A, 5-pin), earthed socket and 4 mm safety sockets (L1/L2/L3, N, PE, PP, CP). Connectors on vehicle side: Type 2 and 4 mm safety sockets (L1/L2/L3, N, PE, PP, CP). Supply: 16 A mains connection cable with earthed plug (L = 1.5 m), 16 A CEE (5-pin) mains connection cable (L = 2 m). Scope of delivery: Measuring adapter in case, cold appliance cable to 4 mm safety tower plug, mini USB cable, calibration certificate. Type of accessory/spare part other. Accessories yes. With case/bag yes. Plug-in technology other. Material of the insulation material other. Measuring circuit category other.