ET 200pro DSE ST direct starter standard mechanically switching electronic overload protection AC-3, 0.9 kW / 400 V 0.15 A...2.00 A without brake contact Han Q4/2 - Han Q8/0 Motor starter SIMATIC ET 200pro for operational switching of three-phase motors in the field, with short-circuit and overload protection and for fully TIA-integrated, highly automated applications, e.g. in conveyor technology. The multifunctional motor starters are fully integrated in the ET 200pro peripheral system. Fast and extensive configuration takes place in the TIA Portal. Use without a control cabinet thanks to the high degree of protection IP65/67. Consistent communication via PROFIBUS and PROFINET. The wide setting range reduces the effort required for storage and configuration with little device variation. The simple installation using a wiring bus and plug-in technology enables the motor starters to be replaced quickly and increases system availability. The Motor Starter ES software is available for project planning, commissioning, operation and diagnostics. PROFIenergy supports active and efficient energy management. The devices are approved worldwide (e.g. IEC, CCC and UL/CSA) and IE3/IE4ready.Available as a direct or reversing starter with various motor current ranges, as a standard or high-feature variant (including soft start function).An optional repair switch module can be used to ensure safe isolation for all downstream motor starters during repair work. In addition, there is a fail-safe repair switch and a shutdown module for fail-safe applications.Motor starter ET 200pro - compact and intelligent.