The Harmony XPS Universal safety relays are characterized by their range of functions and diagnostic capabilities, which reduce downtime in the event of a fault. This safety relay includes safe standstill detection by measuring the remanent voltage, so that no further sensors need to be installed. To do this, the motor cable is connected to the standstill monitor and the voltage induced by the expiring rotary movement is measured after the motor is switched off. If the measured remanent voltage falls below the limit value set on the front (50-500 mV), the motor is assumed to be at a standstill. In addition, a delay time of 0.5 to 60 seconds can also be set on the front. DC and AC motors in 1- or 3-phase networks up to 690 V can be monitored for motor standstill. This safety switching device has 1 safe relay normally open contact, 1 semiconductor signaling output and 1 diagnostic message as an output. With the help of the qualified diagnostics, states and errors are detected and transmitted to a standard input of a PLC using a telegram via direct wiring. A ready-made function block for common control systems evaluates these messages so that the operator is fully informed on the machine display. The supply voltage is 48-240 VAC/DC and the connections are made via removable screw terminals. Applications up to safety level PL e in category 3 or SIL3 can be realized. If the number of outputs is to be increased, the XPSUEP extension can simply be connected to the side via an integrated connector and cross-wiring can be dispensed with, saving time. It is mounted by snapping it onto a top hat rail or screwing it onto mounting plates. A uniquely numbered locking strap is included to protect the settings under the transparent cover. A wide range of approvals enable international use. Thanks to the Green Premium environmental label, you can receive detailed information on material content, environmental impact and circular economy that supports your sustainability goals.