Harmony Control. This network monitoring relay monitors three-phase networks (200-240 VAC) for phase sequence, phase failure and phase asymmetry (5-15%). Two relay changeovers are available for reporting, which can be loaded up to 8 A. The limit value for the asymmetry and a switch-off delay for the output can be set. The settings are made using control elements on the front, which can be protected against changes under a transparent cover. An illuminated scale arrow makes it very easy to see the setting of the potentiometers, even from a distance. The diagnostic switch on the front enables the output relays to be switched off to test the entire application. When the transparent cover is closed, the diagnostic switch is automatically reset. Three LEDs show the status. The width is 22.5 mm and it is mounted on the top hat rail. The power is supplied from the measuring circuit. The cable is connected using screw terminals.