Spacelogic KNX USB interface DIN rail. For connecting a programming or diagnostic device with a USB 2.0 interface to the KNX. The USB connector (type C) is galvanically isolated from the KNX bus. It can be used as a programming interface for the ETS software version 4 (or higher). The device is programmed locally with the physical address and has no programming button and no programming LED. With 2 status LEDs. The KNX USB interface supports KNX longframe communication and is compatible with KNX security telegrams/devices. This enables faster KNX downloads if the target device supports this (e.g. MTN6725-0001). For mounting on a TH35 top hat rail in accordance with EN 60715. The bus is connected via a bus connection terminal. Device width - 1 module approx. 18 mm. Contents - With bus connection terminal and cable cover.