| Complementary |
| Dielectric losses | < 0.2 W/kvar |
| Power losses | < 0.5 W/kVAr |
| Capacitance tolerance | - 5 % to 10 % |
| Voltage test | 2.15 x Un AC between terminals for 10 s; = 660 V - 6 kV AC between terminal and container for 10 s |
| Inrush current | 250 x In |
| Maximum switching operation per year | 7000 |
| Service life in hours | 130000 h |
| Dielectric material | Metallized polypropylene film with Zn/Al alloy, special resistivity & profile, special edge (wave cut) |
| Impregnation material | Non-PCB dry PUR resin; Biodegradable |
| Type of installation | Indoor installation |
| Connections - terminals | ClampTite terminal |
| Mounting mode | Upright/horizontal |
| Diameter | 116 mm |
| Height | 242 mm |
| Net weight | 2.5 kg |
| Contractual warranty |
| Warranty (in months) | 18 |
| Environment |
| Standards | IEC 60831-1; IEC 60831-2 |
| IP degree of protection | IP20 |
| Operating altitude | 2000 m |
| Temperature class | D |
| Ambient air temperature for operation | -25…55 °C |
| Relative humidity | 95 % |
| Logistical informations |
| Country of origin | IN |
| Main |
| Range | PowerLogic |
| Range of product | PowerLogic |
| Product or component type | Heavy duty capacitor |
| Product name | PowerLogic PFC Capacitor |
| Network frequency | 50/60 Hz |
| Series name | HDuty |
| Electrical parameters | 22.6 kvar 380 V 50 Hz; 27.1 kvar 380 V 60 Hz; 25 kvar 400 V 50 Hz; 30 kvar 400 V 60 Hz; 26.9 kvar 415 V 50 Hz; 32.3 kvar 415 V 60 Hz |
| Maximum permissible voltage | 1.1 x Un (8 hours over 24 hours) |
| continuous overcurrent capacity | 1.8 x In |
| Rated voltage | 380…415 V AC 50/60 Hz |
| Packing Units |
| Unit Type of Package 1 | PCE |
| Number of Units in Package 1 | 1 |
| Package 1 Height | 19.000 cm |
| Package 1 Width | 19.000 cm |
| Package 1 Length | 31.500 cm |
| Package 1 Weight | 3.051 kg |
| Unit Type of Package 2 | S06 |
| Number of Units in Package 2 | 15 |
| Package 2 Height | 75.000 cm |
| Package 2 Width | 60.000 cm |
| Package 2 Length | 80.000 cm |
| Package 2 Weight | 58.765 kg |
PowerLogic PFC capacitors are a reliable and flexible solution for power factor correction under demanding operating conditions. These capacitors are mainly used where there are higher voltage disturbances or where there are small non-linear loads. The current rating of the capacitors must be increased to handle the harmonic current load. This capacitor delivers a nominal output power of 25 kVar at 400V AC, 50 Hz. The fixing is ensured by a ClampTite clamp. This component complies with IEC 60831-1 and IEC 60831-2 standards. The weight of the product in the housing is 2.5 kg.