This Acti9 electrical accessory is a changeover contact (NO/NC) to indicate the position of the circuit breaker in the event of an electrical fault or trip. Operating current is 6A from 24VAC to 240VAC, 3A from 277VAC and 415VAC at a frequency of 50Hz to 60Hz. Operating current of 6A is at 24VDC, 2A at 48VDC, 1.5A at 60VDC, 1A at 110VDC and 130VDC. It has 1 position switch with type 1 changeover contact. Intended for installations in small commercial premises, buildings, critical infrastructure, healthcare, industry, data centers. This OC contact is compatible with Acti9 ranges such as C120, C60H-DC, SW60-DC, C60PV-DC. The SD is used for either the device short name or the compatibility code. The mechanical indicator is provided in the product for local signaling. It has a screw terminal connection on the bottom. The connector allows rigid copper cables with a cable cross-section of 0.5mm² to 2.5mm². It has a screw terminal connection on the bottom. The connector allows flexible copper cables (2 cables) with a cable cross-section of 1.5mm². It has a screw terminal connection on the bottom. The connector allows flexible laying of copper cables with ferrule (2 cables) with a cable cross-section of 1.5mm². The Ui rated insulation voltage is up to 500 V. The rated impulse voltage Uimp is 4 kV. It can be mounted on a DIN rail for modular installation. The width in 9 mm pitch is 1. The dimensions are (W) 9 mm x (H) 85.3 mm x (D) 68 mm. The color of the product is white. The product weight is 30g. The pollution degree is 3. The tropicalization degree is treatment 2. The stripping length is 9mm. The terminal tightening torque is 1N.m (below) for screwdriver type PZ1. The IP protection degree is IP20. The operating temperature range is -25°C to +70°C. The storage temperature range is -40°C to +85°C. This product meets EN/IEC 60947-5-1 and GB/T 14048.5 standards. It has EAC and CCC quality labels and is certified with CE and UKCA certificates.