This Acti9 electrical accessory is a changeover contact (NO/NC) to indicate the OPEN or CLOSED position of the circuit breaker. Operating current is between 2mA and 100mA at a frequency of 50Hz to 60Hz at 24VAC to 240VAC &, 24VDC to 220VDC. Open / Closed, auxiliary contact. It is intended for new or renovated installations in small commercial premises, buildings, critical buildings, healthcare, industry, data centers and infrastructures. This electrical accessory is compatible with Acti9 ranges such as iC60, iID, iDPN ARC, iDPN Vigi, iDPN Vigi ARC, iSW, iC40, iC40 ARC, iCV40, iCV40 Vigi ARC, iC40 XA, iCV40 XA and iC60 RCBO. This OC contact is compatible with Acti9 devices such as Acti9 iDT40, iDT40 XA, iDD40 and iKQE RCBO. Screw terminal connection on the bottom. The connection allows rigid copper cables. The cable cross-section ranges from 1mm² to 4mm². The iOF is used for either the device short name or the compatibility code. Screw terminal connection on the bottom. The connection allows rigid copper cables. The cable cross-section ranges from 1mm² to 4mm². Screw terminal connection at the bottom allows a cable cross-section of 0.5 mm² to 2.5 mm² for flexible copper cables. Screw terminal connection on the bottom. The connection allows rigid copper cables. The cable cross-section 2 cables allows a cable cross-section of 2.5mm². It has a screw terminal connection at the bottom. The connection enables the flexible use of copper cables with ferrules (2 cables). The cable cross-section is 1.5 mm². The rated insulation voltage (Ui) is up to 500 V. The rated impulse withstand voltage (Uimp) is 4 kV. The width in 9 mm pitch is 1. The dimensions are (W) 9 mm x (H) 86 mm x (D) 73 mm. The color of the product is white (RAL 9003). The pollution degree is 3. The tropicalization degree is treatment 2. The tightening torque of the connection is 1 N.m (bottom) for the screwdriver type PZ1. According to the IEC 60529 standard, the IP protection degree is IP20. The operating temperature is between -25 ° C and + 70 ° C. The storage temperature is between -40 ° C and + 85 ° C. This product complies with the EN/IEC 60947-5-1 and EN/IEC 60947-5-4 standards. This product is certified with the CE and UKCA mark.