This Acti9 electrical accessory is a changeover contact (NO/NC) to indicate the OPEN or CLOSED position of the circuit breaker. Operating current from 100mA to 6A at a frequency of 50Hz to 60Hz at 240VAC and from 100mA to 3A at a frequency of 50Hz to 60Hz at 415VAC. Operating current at 100mA at 24VDC to 130VDC. Operating current of 6A is at 24VDC, 2A at 48VDC, 1.5A at 60VDC, 1A at 110VDC and 130VDC. It has 1 position switch with 1 changeover contact type contacts. Intended for installations in small commercial premises or buildings. This electrical accessory is compatible with the Acti9 ranges such as iC60 double terminal block and iID double terminal block. The iOF is used either for the device short name or the compatibility code. Screw terminal connection on the top. The connection allows rigid copper cables. The cable cross section ranges from 1mm² to 4mm². Screw terminal connection on the top allows a cable cross section of 0.5 mm² to 2.5 mm² for flexible copper cables. Screw terminal connection on the top. The connection allows rigid copper cables. The cable cross section 2 cables allows a cable cross section of 2.5mm². It has a screw terminal connection on the top. The connection is flexible with ferrule copper cables (2 cables). The cable cross section is 1.5 mm². The rated insulation voltage (Ui) is up to 500 V. The rated impulse voltage (Uimp) is 4kV. The width in 9mm pitch is 1. The dimensions are (W) 9 mm x (H) 86 mm x (D) 73 mm. The color of the product is white (RAL 9003). The pollution degree is 3. The tropicalization degree is treatment 2. The tightening torque of the connection is 1N.m (below) for the screwdriver type PZ1. According to the IEC 60529 standard, the IP protection degree is IP20. The operating temperature ranges from -35°C to +70°C. The storage temperature ranges from -40°C to +85°C. This product complies with EN/IEC 60947-5-1 and GB/T 14048.5 standards. This product is certified with the CE and UKCA marking.