Notching tool for notching outlets in the side rails of cable protection ducts and unperforated industrial ducts on site. To carry out the punching process, an additional drive (basic device) with a UNF 19 connection thread (common connection thread for hydraulic punching tools) with a cutting force of approx. 70 kN must be ordered from an electrical wholesaler. For individual punching processes, we recommend hand hydraulics. The edge protection tape must be used as cable protection and in personal danger areas! for cable protection ducts : = LLK/LUK 60.060 for unperforated industrial ducts : LUE 60. ... for perforated industrial ducts : LI 60. ... Dimensions (approx. dimensions) L x W x D : 162 mm x 72 mm x 100 mm Punching information for notch hole size L x H : 50 x 55 mm in sheet steel/stainless steel t : = 0.9 mm Material : tool steel