Cantilever/suspended support, for wall and suspended support mounting on walls and horizontal ceilings, including hot-dip galvanized fastening accessories. For static reasons, the TKSD 20 F spacer must be installed for wall and ceiling mounting to avoid deformation of the trapezoidal profile when tightening the fastening screw. Please order fastening screw SKM 10X25 E3 in accordance with DIN EN ISO 4017 separately. The TKSD 20 F spacer is also required for suspended support mounting with cantilever fastening on both sides. Please order fastening screw SKM 10X70 E3 in accordance with DIN EN ISO 4017 separately. The load-bearing capacity information only applies if the system is sufficiently anchored to the supporting surface or if it is installed correctly on suspended supports. Please observe additional regulations for use in functional maintenance! Dimensions (approx. dimensions) H x W x L : 132 x 57 x 313 mm Load capacity F at L/2 : 0.9 kN tested in the system Material : Steel, hot-dip galvanized according to DIN EN ISO 1461