Cable protection duct T-piece 90°, with snap-on cover, duct bottom part unperforated, connection lugs with earthing lug aligned with the duct, these must be bent at right angles to the pre-stamped notches on site for the outlet, the potential equalization between the ducts is carried out via the joint connector LST...E3 and the potential equalization cable GSLH... (please order separately), with the covers automatically when snapped on. Use for: Cable protection ducts LLK...E3 / LUK...E3 Dimensions (approx. dimensions) Main direction H x W: 100 x 100 mm Outlet H x W: 100 x 100 mm The height of the outlet corresponds to the height of the main direction! Length L: 350 mm Material: Stainless steel, material no. 1.4301, AISI 304