GRP cable tray, pressed, with unperforated side rails and base, with molded connector and with transverse reinforcements (5 mm) over the entire cable tray width in the base, mechanical strength according to IEC 61537, please order appropriate fastening accessories separately, halogen-free. Due to the transverse reinforcements, the cable tray is also approved for use with high-frequency cables in accordance with UTE C15-900 (application class D, frequency 16 MHz). An expansion distance of 8 mm must be taken into account. Due to the expansion of the material, the following must be observed during assembly: - The cable tray should not be screwed close to or at the joint. - When screwing the cable tray onto the brackets, a through hole of Ø 9 mm for the FKM 6X20 E4 screws must always be made in the tray. Article also available in ...AC (resin mixture with acrylic resin). Dimensions (approx. dimensions) H x W : 80 x 200 mm Material thickness t : 3 mm Bottom bead shape : 60 x 5 mm Bottom bead shape Grid dimension : 313 mm Load capacity F at a support distance of 1.5 m : 0.5 kN/m Delivery length : 3000 mm Usable cross-section : 13320 mm² Material : UP-GF (glass fiber reinforced polyester) Color : pebble gray RAL : 7032 (similar)