Splice distributor for mounting rail TH35 without front panel, grey housing, with or without splice cassette with crimp splice holder (CSH) for up to 12 splices, two shrink splice holders (SSH) can be mounted on the splice tray, with fibre reservoir, freely labelable label strip, fastening on the mounting rail via very robust mounting rail holder, various installation variants on the mounting rail possible, for various front panels 3HE/7TE, cable feed from above or below, straight or diagonal, with M20 screw connection (up to 2 possible), 50 mm wide, 128 mm high, 132.5 mm deep (from mounting rail, without couplings), introduction of pre-assembled cables possible, one M20 cable entry with strain relief included in delivery, fastening of the housing cover using just one screw, variants: with splice cassette, without splice cassette, Attention: Not all front panels available on the market can be used 3HE/7TE can be used for the OpDAT REGpro. When using pre-assembled cables, the version without splice cassette is recommended.