The analog value transmitter is used for manual setting of the manipulated variable, e.g. for mixing flaps, valve positions, temperature values, etc. The module can be controlled by two operating modes, which are set using the three-stage switch (ON, OFF, AUTO) on the front. The switch position is reported back via the external control contact terminals B1 and B2. Switch position ON: The manipulated variable can be set using the potentiometer on the front. The output signal 0 to 20 mA is available at terminal Y. The current flow at input YR is not interrupted in the switch position ON / OFF. Switch position AUTO: The input current (YR) is transmitted to the manipulated variable output Y with a tolerance of ± 5% (scale end value). , connection with spring-loaded terminals (push-in), setpoint transmitter, manual control level with feedback, LED brightness proportional to the manipulated variable