Battery
Battery technology	Sealed Lead Acid (VRLA)
Battery capacity	7 Ah
Battery voltage	48 V
Number of batteries supported	4
Typical backup time at half load	7 min
Battery recharge time	3 h
Automatic battery test
Certificates
Certification	CE, EN 62040-1, EN 62040-2
Design
Product colour	Black
International Protection (IP) code	IP21
LED indicators
Features
UPS topology	Double-conversion (Online)
Output power capacity	2 kVA
Output power	1800 W
Waveform	Sine
Input operation voltage (min)	160 V
Input operation voltage (max)	300 V
Input frequency	45/65 Hz
Output operation voltage (min)	230 V
Output operation voltage (max)	230 V
Output voltage regulation	1%
Number of input phases	1
Efficiency	90%
Power factor	0.98
Input power factor	0.99
Crest factor	3:1
Output voltage Total Harmonic Distortion (THD)	3%
Noise level	50 dB
Management protocols	SNMP
Audible alarm modes	Alarm when on battery, Fault, Low battery alarm, Overload alarm
Emergency Power Off (EPO)
Audible alarm(s)
Web-based management
Operational conditions
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80%
Ports & interfaces
AC outlet types	C13 coupler
Power plug	C14 coupler
AC outlets quantity	6 AC outlet(s)
Serial interface type	RS-232
RS-232 ports	1
Serial interface
Emergency Power Off (EPO) connector
Weight & dimensions
Width	322 mm
Depth	151 mm
Height	444 mm
Weight	17 kg

The UPS system provides a power range of 1000 VA to 3000 VA. The design of the UPS system was concentrated on a central circuit board that works together with all power components, the control and the diagnostic units. All models have an integrated battery system with a standard bridging time. This can be extended at any time with additional battery units. All versions have an expansion slot that can be equipped with a network card. This enables direct integration into a network.