REG housing 2 TE
new system function: fully encrypted radio transmission (AES-CCM) from eNet Server software version 2.0
Intended use
Control of electrically operated blinds, such as blinds, roller shutters and awnings
Operation with suitable eNet radio transmitters
Operation with power supply 12 V REG (item no. NT 1220 REG VDC) and eNet radio receiver module REG (item no. FM FK 32 REG) or eNet server
Installation on top hat rail according to DIN EN 60715 in sub-distribution board
Product features
Operating mode switch for switching to blind actuator, roller shutter actuator or parameterization via eNet server
Positioning of blinds and slats via scene call
Position for sun protection and twilight can be saved
Status feedback to radio transmitter
Output can be switched with Prog button Blind
running time can be saved Slat reversing time can be saved Fabric tightening for awnings Status display with LED Can be set with eNet server: Reversal time when changing direction Direction of travel can be inverted Operating locks Position for sun protection, twilight, lock-out protection and wind alarm Additional functions with eNet server: Fully encrypted radio transmission (AES-CCM) from eNet server software version 2.0 Update of device software Read error memory Nominal voltage: AC 230 V ~, 50/60 Hz Ambient temperature: ?5 ... +45 °C Minimum control time in blind operating mode: 0.1 s Roller shutter: 0.3 s Contact type: µ Standby power: max. 0.2 W Running time: 1 ... 600 s Factory setting running time: 120 s Slat adjustment time: 0 ... 10 s Connected load motors: 1000 W Connection load terminals: Screw terminals single-wire: 1 x 1.5 ... 4 mm2 fine-wire without wire end ferrule: 1 x 0.75 ... 4 mm2 fine-stranded with wire end ferrule: 1 x 0.5 ... 2.5 mm2 Installation width: 36 mm (2 HP) Bus line Nominal voltage: DC 12 V SELV Current consumption: max. 20 mA Bus connection: connection terminal Cable length: max. 3 m