REG housing 4 TE
ETS product family Output
Product type Analog output 4-way
The analog output requires the power supply to operate Item no.: WSSV 10.
Function
The KNX analog output has 4 analog outputs and converts KNX telegrams (1-byte and 2-byte) into analog output signals.
These analog output signals enable actuators in heating, air conditioning and ventilation technology to adapt their output variables based on bus information and to participate in control processes.
The outputs are parameterized by the software to voltage and current signals. Voltage signals: 0 ... 1 V, 0 ... 10 V Current signals: 0 ... 20 mA, 4 ... 20 mA
Voltage outputs are monitored for short circuits.
The output state is displayed by status LEDs.
Using the 4-way analog output module (item no. 2204.01 REGAM), the number of analog outputs can be increased by 4 to 8. The connection is made via a system plug.
The output variables can be forced. Outputs
that are not required can be switched off.
Connectable analog actuators
Do not connect any electronic ballasts or electronic transformers with a 1 ... 10 V control input to the outputs!
Do not connect any external voltages to the outputs. Connected components must ensure safe separation from other voltages.
Current outputs may be loaded with a maximum of 500 ?.
Voltage outputs must be loaded with a minimum of 1 k?.
The GND terminals of the outputs K1 ... K4 are connected internally.
If a voltage output is short-circuited between K1 ... K4 and GND, the respective output is switched off.