INTELLINET 561617, EAN: 766623561617

INTELLINET 561617

INTELLINET 561617

Lieske Part No.1610453
Mfg Part No561617
EAN-Code766623561617
Manufacturer INTELLINET
Here only 86,76 EUR
103,24 EUR incl. VAT

Further information for INTELLINET 561617

Extends PoE range by 100 m, PoE power budget 90 W, four PSE ports with 30 W max. output power each, IEEE 802.3bt compliant (PoE++ / 4PPoE), metal housing
Gigabit PoE++ Extender < doubles the range of your Power over Ethernet Connection:
The 4-Port Gigabit Ultra PoE Extender from Intellinet Network Solutions increases the range between the PoE source and four end devices by 100 m. It does not require a separate, external power supply, but is powered directly by an injector or PoE switch. Since the standard range of PoE is already 100 m, the possible total distance increases to a huge 200 m.
Cost savings thanks to less cabling:
This repeater significantly reduces your installation effort: you no longer need sockets for devices such as WLAN access points, network cameras or VoIP telephones Install and run separate power cables, even if they are far away from the PoE source. Use the usual advantages of Power over Ethernet and supply the end devices with both data and power with a single Cat5e/Cat6 network cable.
802.3bt compliant:
This gigabit extender supports the new IEEE 802.3bt protocol over all four pairs of wires (4PPoE), which allows a power budget of a whopping 90 W and up to 30 W per port on IEEE 802.3at or IEEE 802.3af. compliant devices. The cable length can be up to 100 m in front of and behind the extender, for a total range of 200 m.
Easy installation:
When designing this extender, emphasis was placed on particularly easy setup < simply connect your injector or switch to the < In < and the PoE end device such as VoIP phone or camera to the <Out< That's all. No further configuration is necessary.
  • Doubles the maximum connection range between PoE source and device from 100 m to 200 m
  • Power supply and network connection for four PoE devices such as network cameras, access points or VoIP phones through PoE injector or PoE switch
  • Delivers up to 90 W four connected PoE devices with up to 30 W per port
  • Supports data transfer rates of 10/100/1000 Mbit/s
  • PoE power budget 90 watts
  • Saves time and installation costs by transmitting data and power over the existing network cables
  • Power is only transmitted to IEEE 802.3af/at-compliant devices, non-PoE-capable devices only receive data
  • Protection against overvoltage, overcharging and voltage spikes
  • Ground point for protection against external electrical voltage spikes
  • Does not require additional power supply; draws power directly via the PoE input
  • Compatible with IEEE 802.3bt/at/af-compliant PoE injectors and switches (PSE)
  • Compatible with all IEEE 802.3at/af-compliant Powered Devices (PD)
  • Can be used as a 5-port Gigabit switch with PoE power supply and PoE passthrough
  • 10 Gbit/s switch fabric
  • Supports jumbo frames up to 9 kByte
  • Supports 2048 MAC address entries
  • LEDs for PoE and data connection
  • Fan-free design for quiet operation
  • Compact metal housing
  • Rubber feet for non-slip use in desktop applications
  • Fully NDAA compliant
  • 3 year warranty Standards
  • IEEE 802.3af (Power over Ethernet)
  • IEEE 802.3at (High-Power PoE+ Power over Ethernet)
  • IEEE 802.3bt (Ultra PoE++/4PPoE Power over Ethernet)
  • IEEE 802.3 (10Base-T Ethernet)
  • IEEE 802.3ab (Gigabit Ethernet)
  • IEEE 802.3x (Full duplex and flow control)
  • IEEE 802.3u (100Base-TX Fast Ethernet)
  • General
  • Supported media:
  • 10Base-T Cat5e UTP/ STP RJ45, 8-pin
  • 100Base-TX Cat5e UTP/STP RJ45, 8-pin.
  • 1000Base-T Cat5e UTP/STP RJ45, 8-pin.
  • Ports:
  • 1 x RJ45 10/100/1000 Mbit/s input
  • 4 x RJ45 10/100/1000 Mbit/s PoE output port
  • MAC address table: 2048 entries
  • Cache: 256 kB
  • Backplane speed: 10 Gbps
  • Store-and-Forward Architecture
  • Certificates: FCC Class A, CE, RoHS
  • LEDs
  • PoE
  • Link/Activity
  • PoE Pins
  • Pin 1: DC (+)
  • Pin 2: DC (+)
  • Pin 3: DC (-)
  • Pin 6: DC (-)
  • power supply
  • Max. PD output current: 30W per port, 44 - 57V
  • Input current: IEEE 802.3bt/at/af compliant PSE, 90W max., 50 - 57 VDC
  • ambient conditions
  • Metal housing
  • Dimensions: 130 x 86 x 29 mm
  • Weight: 337 g
  • Operating temperature: 0 - 40°C
  • Storage temperature: -10 - 70°C
  • Humidity: 20% - 85% RH, non-condensing
  • Scope of delivery
  • 4 -Port Gigabit Ultra PoE extender
  • Four rubber feet
  • Quick start guide Color: Black Product dimensions: 130 (L) x 86 (W) x 29 (H) [mm]
This is an offer of:

Lieske Elektronik e.K.

Reutener Str. 10
79279 Vörstetten

http://industry-electronics.com
Tel. 07666/88499-0
Fax. 07666/88499-111

Diesen Artikel finden Sie unter:
industry-electronics.com/artikel/1610453
qrcode für INTELLINET 561617