The SignalTEK 10G PRO for the qualification of active and passive copper and fiber optic links over 10 Gbit/s determines the actual bandwidth available in the network and identifies bottlenecks to prove whether a cabling supports transmission up to 10 Gbit/s according to IEEE 802.3. Using automatic tests, the SignalTEK 10G provides a precise statement and evaluation. The compact tester is characterized by user-friendly operation, a 5' high-resolution touchscreen display and a sturdy housing. The integrated WiFi connectivity enables the SignalTEK 10G to connect directly to the free AnyWARE Cloud Management System. The SignalTEK 10G PRO supports the full range of copper/fiber optic/network and troubleshooting options such as transmission tests (network), 100 Mb/1Gb/10 Gb, application range test (CCTV, video, web data), VLAN detection, multi-PING, event log (max. 72h), packet statistics for IP and MAC layer, IP conflict, uptime test, packet errors, jitter and delay, user-defined bandwidth test, wire plan check, short circuits, open ends, split pair, length measurement and fault diagnosis with TDR technology. Bidirectional testing of network connections of copper and fiber optic cables according to IEEE 802.3 standards, skew (ns) and transmission tests 100/1000 Mbit/s /2.5/5/10 Gbit/s. Diagnosis of fault locations on the fiber optic, display of the optical TX/RX level, detection of defective SFP modules, support of SFP/SFP+ (MM + SM). Test of maximum bandwidth, hub blinking, ping and trace route, port detection (LLDP/CDP/DCP), IPv4/IPv6 support and statistics. Verification of PoE installations up to 90 W (PoE++), testing of all PoE classes (0-8) and PoE types (af/at/bt), display of voltage and PoE wire pairs, tone generator for cable detection (with compatible inductive receiver R180001). TeamViewer Live Support to assist with device diagnostics. Configurable autotest function for quick testing of common applications. PDF report of test results.