Technical data:

Special drag chain cable for extreme mechanical stresses in accordance with DIN VDE 0285-525-2-51/ DIN EN 50525-2-51, DIN VDE 0285-525-2-21/ DIN EN 50525-2-21 in accordance with UL Std.758 AWM Style 20939
Temperature range moving -30°C to +80°C fixed -40°C to +80°C Nominal voltage DIN VDE U0/U 300/500 V UL 600 V
Test voltage 3000 V
Insulation resistance min. 100 MOhm x km
Minimum bending radius moving 7.5x cable Ø fixed 4x cable Ø
Radiation resistance up to 100x106 cJ/kg (up to 100 Mrad)
Structure:
Bare copper wire, fine-wire Unilay with short Lay lengths Core
insulation made of special PP
Core identification according to DIN VDE 0293 Black cores with continuous white numbering
Stranding: < 7 cores: with optimal lay length, due to the design, stranded in one layer around a filling element = 7 cores: cores with optimal lay lengths stranded in a bundle construction, low-torsion stranding with coordinated short lay lengths around a filling element
Outer jacket made of special PUR,
extruded to fill
the gussets Jacket color: black (RAL 9005) with meter marking
Properties:
The materials used in production are free from silicone and cadmium and free from substances that impair paint wetting
Tests:
PUR jacket flame retardant according to DIN VDE 0482-332-1-2, DIN EN 60332-1-2/IEC 60332-1, UL VW-1, CSA FT1
low adhesion
halogen-free
very good alternating bending strength
longer service life due to low Friction resistance
High tear, abrasion and impact strength even at low temperatures
Higher notch toughness
Increased stability
Oil resistant
Better chemical resistance
Ozone and UV resistant
Increased efficiency
Reduced in Ø, thus lower moving masses
Notes:
Shielded analogue type: MULTISPEED 500-C-PUR UL/CSA
Use:
UL/CSA approved HELUKABEL MULTISPEED 500-PUR is used when extreme demands are placed on the cable. Coordinated materials and stranding techniques allow continuous use as a highly flexible drag chain cable with long travel distances and high or slow speeds in dry, damp and wet rooms, as well as outdoors. These special robust and abrasion-resistant control cables are used where problems arise with permanently flexible loads, such as in energy chains, on industrial robots, production lines, automation systems and on permanently moving machine parts for continuous use in multi-shift operation. They are used in particular wherever the highest demands are placed on flexibility, abrasion resistance, ozone and chemical resistance. For applications that go beyond standard solutions (e.g. composting plants or high-bay conveyor systems with extremely high travel speeds, etc.), we recommend that you use our specially developed questionnaire for energy guiding systems. For further application parameters, see the selection table: Cables for energy guiding chains in the introduction. For use in energy guiding chains, please observe the installation instructions.
Standard lengths: 100 m, 500 m, 1000 m.
Technical changes reserved.