General
Mounting method	Hollow wall
Number of rows	2
Width in number of modular spacings	12
Type of cover	Door
Cover model	With notch
Material housing	Plastic
Height	880.5 mm
Width	348 mm
Depth	94.5 mm
Built-in depth	90 mm
Internal depth	91.5 mm
Colour	White
RAL-number	9010
Degree of protection (IP)	IP30
Type of closure	Other
Built-in height	846 mm
Built-in width	314 mm
Type of door	Single
Transparent cover/door
DIN-rail
With mounting plate
Extension possible
With lock
Sealable

Hybrid, volta, hollow wall, 24PLE, 2 mounting plates, with socket + plastic door. Small installation distributor for hollow wall installation made of plastic, tested according to DIN VDE 61439-3. Rated voltage max. 400V/50 Hz, protection class IP30.
Consists of plastic wall box with standard cable clamp and break-out cable entry slide with snap fastening and integrated spirit level. Hollow wall fastening with quick-fixing lever, can be mounted on the side or top/bottom. Cover frame made of sheet steel, powder-coated and baked. 15 mm plaster compensation possible. Ventilation door with non-transparent plastic plate for better propagation of the WLAN signal compared to a sheet metal door. Ventilation slots at the bottom and top in the plastic plate to better dissipate the waste heat. Protection class IP30, white RAL9010, flush with internal, manually operated hinges. Door lock with flush-mounted recessed grip and automatically folding back handle. Door hinge on the right or left without dismantling the frame.
2-row device carrier made of galvanized sheet steel. 2-row device cover made of plastic for 24 (28) modules with 46 mm device slot, quick-release fastening with 90° rotation on the cable entry slide and on the partition, sealable on both sides as standard. Finger-safe PE/N terminal with plug-in technology in assembly-friendly snap technology. A partition is installed to safely separate the multimedia part and the circuit distribution, which at the same time also allows for the accommodation of up to two sockets. Generous installation space with pre-assembled mounting plate(s) made of galvanized sheet steel with 3.2 mm regular holes in accordance with DIN 24041. Device holders for screwless fastening of devices for direct mounting on the perforated sheet by hanging or screwing are included.
Cable management clips can be installed in the quick-release fasteners provided on the left and right.